[. . . ] We recommend Wide Vision Safety Mask for use over eyeglasses or standard safety glasses with side shields. unmodified plugs and matching outlets will reduce risk of electric shock. Avoid body contact with earthed or grounded surfaces such as pipes, radiators, ranges and refrigerators. [. . . ] Use of the power tool for operations different from intended could result in a hazardous situation. Before further use of the tool, a guard or other part that is damaged should be carefully checked to determine that it will operate properly and perform its intended function. Check for alignment of moving parts, free running of moving parts, breakage of parts, mounting and any other part that is damaged should be properly repaired or replaced by an authorized service center unless otherwise indicated in this instruction manual. Always wear safety goggles and a dust mask when sanding, especially sanding over-head. Extra paper extending beyond the sanding pad can also cause serious lacerations. WARNING Do not throw sanding dust on an open fire because materials in fine particle form may be explosive. WARNING A suitable breathing respirator must be worn while sanding lead paint, some woods and metal to avoid breathing the harmful/toxic dust or air. Have your power tool serviced by a qualified repair person using only identical replacement parts. Do not place the tool on a surface while the belt is still moving since belt rotation will cause it to move, and may result in the tool being damaged or personal injury. Clamp the work piece if it does not remain stationary due to its own weight. Input Power No load speed Belt size Net weight 230 V~50 Hz 800 W 150-300 m/min 76 x 533 mm 3. This tool is started and stopped by squeezing and releasing the trigger (8). For continous operation, press the lock-on button (7) while trigger is being squeezed. The belt speed can be freely adjusted from 150 to 300 m/min by turning the variable speed control (12). (1= lowest speed / 6 = highest speed ) Be sure to check the nameplate on the product, because the voltage is subject to change depending on the area in which the product is to be used. Although the dust bag has a substantial capacity, it should be emptied frequently. [. . . ] The system has been preset at the factory but may required adjustment when belt are changed or an older belt stretches. 175mm (1/8 inch) from the edge of the wear plate, adjust the belt by turning the auto-track adjusting screw until the belt is even with the edge of wear plate. Nu lsai persoane care nu sunt familiarizate cu maina sau care nu au luat la cunotin aceste msuri de siguran s foloseasc maina. [. . . ]